Skip to main content

Example of using a customizable cabinet

Bally
  • Updated
Complete the following steps to customize a cabinet from the DPLUSF01 catalog (Frame cabinets, imperial):

  1. In the Catalog field of the Local Browser, select the catalog DPLUSF01.
     

  2. In the Quick Search field, type TC3 and then select TC3V-R.  

  3. Drag the cabinet anywhere on the Floor Plan.

    The Attributes dialog box opens.

  4. Click the Maximize button in the Attributes dialog box.

  5. Select Section Style 1, scroll nearly to the end, and select the 4-drawer image.

  6. Scroll up the list, select Section Style 2, scroll nearly to the end of the list, and select the microwave image.

  7. Scroll up the list again, select Section Style 3, and then select the wall 2-door image.
    The tall cabinet shown in the following figure should appear in the Attributes dialog box.

  8. Click OK.

  9. Place the cabinet on the floor plan.

  10. Resize the width of the cabinet to 24 inches and click to set.

  11. Double-click on the tall cabinet.

  12. In the Variables tab of the Attributes dialog box, select the Config pane.

  13. Complete Section 1 height and Section 2 height information using the values shown in the following figure. Notice that the last section’s height is adjusted automatically.

    The image of the TC3V-248424R cabinet in the 3D Display pane should now match the image in the following figure.



  14. In the Variables tab, select the Case Construction Type pane.

  15. Select Top Style and then select Full Top.

  16. Select Back Style and then select Nailers inside.

  17. If you want to, you can also select the other Case Construction Type variables and associated values.

  18. Click OK to close the Attributes dialog box.

Related articles