In a double corner cut, two small cuts are created starting at the diagonal line’s front points. The depth of these small cuts is determined by the bull nose depth. They are then joined by their corresponding back points at a right angle. Other available corner cuts for this corner type include: double cut, diagonal cut,
and diagonal w/cutoff.
Complete the following steps to change a bull nose cut to a diagonal cut:
-
Point to the countertop with the cut, right-click, and select Edit Shape.
-
Select one of the double corner cuts and right-click.
-
Point to Double Corner Cut in the pop-up menu, and select Diagonal Cut from the Cut Menu.
The result is shown in the following figure.
To change the bull nose depth, complete the following steps:
-
Point to a counter with a bull nose cut, right-click, and select Attributes. The Attributes dialog box opens.
-
In the Variables tab, enter the new depth in the Bullnose depth field.
-
Click OK.