Bally
- Total activity 2232
- Last activity
- Member since
- Following 0 users
- Followed by 1 user
- Votes 0
- Subscriptions 1735
Articles
Recent activity by Bally-
Rotate an item
To change the angle of an item attached to a wall/construction line or of a freestanding item, use either of the following methods: With the Rotation Handles Select the item (clicking once), ...
-
Rotate a wall group
You can rotate a wall/construction line group using either of the following methods: With the rotation handles To rotate the entire group, make sure the Link mode is enabled. Click once to...
-
Rotate and intersect a countertop and or line
The Rotate & Intersect command allows you to change the angle of a line while maintaining the proportion of the shape. You can use this command for linear items such as moldings. Complete the fo...
-
Rotate a wall
You can rotate a wall/construction line using either of the following methods: With the Rotation Handles on the Floor Plan Select a line to display the wall handles, and then click again to ...
-
How to create a running line
The Running line command allows you to draw adjacent connected lines using points that you specify. Complete the following steps to apply the Running line command: In the Annotations toolbar, ...
-
Rotate the view
To rotate the view in Interactive mode, press and hold the mouse button on the image to display the rotating arrow cursor, and turn the item to the new angle. The following screenshot shows an i...
-
Room layout ribbon
The Room Layout ribbon contains commands for wall layouts, opening items, and room layouts. To draw any number of walls, an L shape, U shape or closed layout using single or double-si...
-
How to set or change room textures
The settings that you assign in the Room Textures section are valid for all new designs that you create until you change the settings again. To change the ceiling and floor coverings for individ...
-
Right point wall justification
Use the front dimension if you have inside wall measurements and are drawing in a clockwise direction. Example: In the Placement box, enter Length = 3' and Angle = 90 for the first wall; and ent...
-
Right extension line
Complete the following steps to resize the extension line on the right side of a dimension line: Point to the dimension line, right-click, and select Right Ext. Line. Move the pointer to res...