Converting a running line into a molding

Please execute the following steps:

1. In the Annotations toolbar, click Running Line.
   
   

2. On the Floor Plan, click to start drawing the running line (make sure to start on the left-hand side).

   Note: If the running line is drawn from the right to the left, the molding will be designed upside down.
   
   

3. Move the pointer to draw the first section of the line (you can also use the Placement box to enter the line coordinates).
   
   

4. Click to confirm the first section of the running line and continue drawing.
   
   

5. Right-click to end drawing the line.
   
   

6. To convert the running line into a molding, right click the running line and click Make 3D.
   
   

7. On the Trims window, double click the desired molding, select a molding and click the Place button.
   
   

8. Next, the molding position will need to be adjusted. This can be done by right clicking on the molding, click on Attributes and change the Up-Down value. It can also be adjusted in an elevation by holding the left mouse button and the CTRL key on your keyboard.

Note: Sometimes, the molding may show invalid pattern lines. This is because the molding exceeds the length specified in the catalog.