The Duplicate command allow you to create a duplicate copy of an item.
Complete the following steps to use the Duplicate command:
-
Point to the item that you want to duplicate, right-click, and select Duplicate.
-
Click in the Floor Plan or Elevation area where you want to place the duplicated item.
Note: If you click in a placement zone, the item becomes attached to the placement zone so that you can drag the item and right-click to pull it in/out on the Floor Plan or move it up/down in Elevation, and right-click again to drag the item.
If you click in the floor area, the item becomes a freestanding item and you can move it around, right-click to rotate it, and right-click again to move it. To snap this item to one or more items on the floor area, click in an area close to the alignment line of these items. The copied item will snap automatically. Items snap automatically based on the specified Snap distance in your preferences. To bypass item snap, use the SHIFT key. -
Click to set the final position.
Note: You can enable/disable the In-Out/Up-Down mode to keep or ignore the item’s current horizontal or vertical placement value. Enabling this mode can be useful, for example, when duplicating an item that needs to be placed at various heights.