Complete the following steps to insert a wall between two connected walls:
-
Point to any wall/construction line, right-click, and select Edit Wall Shape.
-
Point near or on the cut line (corner) joining the two walls where you want to insert the new wall and right-click. If you click closer to the left or right of the cut, the new wall will be inserted left or right of the cut line.
-
In the pop-up menu, point to the Wall # and select Insert.
-
Move the pointer and look at the Placement box to set the length and angle, and click to set.
-
To cancel your changes and exit the Edit Wall Shape mode, click Discard Changes in the Edit Shape ribbon.
To save your changes and exit the Edit Wall Shape mode, click Accept Changes in the Edit Shape ribbon.
The following figure provides an example of a wall inserted between two walls that were originally at a 90-degree angle.