The options available in the Type tab vary according to the level you choose (Wall Group, Wall, or Section). In this tab, you can determine if the group, wall, or section must be a wall or a construction line. If you work on a wall group or a wall, you can also assign an Inside and an Outside placement zone. In combination with the height of walls (Dimensions tab) at their beginning and end, you can also determine the angle of walls to create sloped ceilings.
-
In the left pane of the dialog box, choose the Wall Group, the Wall, or the Section that you want to work on.
To apply changes to specific wall groups, walls, or sections, use the CTRL key to make your selections. -
In the Type pane, select the type (Wall or Construction line) for the chosen level
-
In the Placement Zone(s) pane, select the Inside and/or Outside check box.
-
To connect (or not) the wall(s) to the Ceiling, select one of the three options in the Ceiling pane. See Create a cathedral or sloped ceiling for instructions on creating a ceiling.
-
To apply your changes without closing the Wall Properties dialog box, click Apply.
To apply your changes and close the Wall Properties dialog box, click OK.
To reset the values to the same values as one level up (wall or group), click Reset.
To ignore your modifications, click Cancel.